New Year’s Resolutions for Your Home

Prevent Bathroom Mold

No matter where you live, the high moisture level in your bathroom can cause mold and mildew. Eliminating bathroom dampness is the key to keeping mold from growing. To do that, follow these steps:

• First, after a bath or a shower, squeegee water off the shower walls. That eliminates at least three-fourths of the moisture that supports mold and mildew growth.
• Second, run your bath fans during your bath or shower and for a half-hour after to flush out moisture. Or add a timer switch to make this step automatic.
• Third, if you have tile, seal the grout lines annually with a standard grout sealer to waterproof them.

To get rid of the current mold, scrub with detergent and water, then let the surface dry completely. Or use a solution of ten percent bleach and 90 percent water (a stronger bleach solution will not give better results). Spray or brush on the solution, let it sit ten minutes, then rinse it off and let dry.

If the fans aren’t clearing out most of the moisture in your bathrooms after five to ten minutes, your fans may not be moving enough air. Fans are certified by the volume (cfm, or cubic feet per minute) of air ‘exhausted’ out of the room.

To find the recommended fan capacity for your bathroom, simply multiply the bathroom square footage by 1.1 (assuming an 8-ft. ceiling; for a 9-ft. ceiling, multiply by 1.5).

Article source here: New Year’s Resolutions for Your Home

Article source here: