Make Your Own Moldings
A good set-up and steady push result in a smooth, burn-free molding. Start by tightening the bit into the router, mounting the router in the base and adjusting the height of the bit. Dont worry about getting the fence square to the table; it doesnt matter for this type of cut.
If your bit has a bearing guide, lay a straightedge against the fence and adjust it until theres a paper-thin space between the outer edge of the bearing and the straightedge. Clamp feather boards to the table and the fence to hold the work against the bit. This allows you to concentrate on pushing the board.
To avoid burn marks from the router bit, feed the board at a steady rate without stopping. The rate of feed depends on the bit and type of wood. With experience, youll learn to judge the best rate by listening to the router and feeling the resistance as you push against the board.
Cuts more than about 3/8 in. deep can strain the router motor, put undue pressure on the bit, and leave a rough or chipped surface on the wood. To avoid this, adjust the fence so the bit removes about two-thirds of the wood with the first pass. Then readjust the fence and make the final pass at a faster feed rate.
Article source here: 6 Router Table Tips and Techniques
No comments:
Post a Comment