If this workbench looks familiar, it’s probably because you’ve seen one a lot like it in your father’s or grandfather’s shop. Variations of this design have been around for decades, and for good reason: The bench is strong, practical and super easy to build. You can run to the lumberyard in the morning, grab a few boards, and by noon you’ll have a perfectly functional workbench.
The workbench isn’t fancy—it’s built from standard construction lumber. But you can easily customize it with drawers or other features now or later. To see some of the improvements you can make, visit DIY Workbench Upgrades.
Cut the parts according to the Cutting List. We used a miter saw, but a circular saw will work fine. Mark the 2x4s with a speed square or combination square. Then carefully cut the boards to length. If you plan to stain or paint the bench, now is the time to sand the parts. And to really simplify your job, you could also stain or paint the parts before you assemble the bench.
The overall dimensions of the DIY workbench are: 60′ wide x 28-1/4′ deep x 36′ tall plus a 7-3/4′ backboard.
Build the Top and Shelf Frames
- Use 3-in. screws to assemble the frames that support the top and the shelf. To avoid splitting the 2x4s, either drill pilot holes or use self-drilling screws. Build both frames and set the top frame aside.
- Note: We used an old door propped up on sawhorses as a work surface, but the floor will work too.
- Lay the 2x4s for the front and back of the top and shelf on the work surface and mark the centers.
- Pro tip: Remember, if you’re not using self-drilling screws, drill pilot holes for the screws. Photo 1 shows how to assemble the frames. Set the top frame aside and screw the shelf boards to the shelf frame (Photo 2).
Article source here: Classic DIY Workbench Plans
No comments:
Post a Comment