How To Fix a Gas Stove That Won’t Light

Gas Stove Not Lighting: No Gas

If all of the burners won’t light, check the gas supply valve behind stove to make sure it’s on. The gas valve handle should be in-line with the gas line. When you’re sure the gas is on, follow these steps:

• Lift up the burner cap and set it aside.
• Using a flashlight, look for a brass-colored piece with a small hole in the center. This is called the gas orifice.

• Straighten out a metal paperclip, so it’s as long as possible.
• Push the end of the straightened paperclip down into the small hole in the center of the brass piece. The hole is usually less than one inch down inside the gas burner, but can be as deep as four inches.
• Rotate the paperclip in the hole four full revolutions to break up any blockage.
• Remove the paper clip.
• Put the burner cap back on. Make sure that it sits completely flat. You may need to wiggle it around to get it to sit completely flat against the burner.
• Test your gas stove burner. It should now light right away and the flame should be stronger.

When you light the burner, the gas will jettison the clog you broke up.

If you don’t have a spark, try option two.

Article source here: How To Fix a Gas Stove That Won’t Light